FILTRATION & PURIFICATION
Protect your process from the contamination that holds it back. Connect the contaminant, operating conditions and required outlet quality to a suitable filtration or separation approach.
Choose your location to discuss product selection and application support. Availability varies by branch.
START WITH THE APPLICATION
Short filter life, rising pressure loss and off-spec product can point to different separation problems. Identify whether the unwanted material is a particle, a liquid droplet, vapor or dissolved material. Then define the outlet quality the process needs.
Regenerable designs remove collected solids through a cleaning cycle. Evaluate contaminant behavior, cleaning utilities and waste handling as well as throughput. Whether flow continues during cleaning depends on the selected configuration.
Capture particles in liquid or gas streams. Compare removal efficiency, dirt-holding capacity and pressure loss alongside media compatibility. The housing, element seals and service conditions are part of the selection.
Combine small droplets so the separated liquid can drain or disengage. Identify the continuous phase, dispersed liquid and solids burden. Upstream particulate removal can protect the coalescer; emulsions and fluid chemistry require application review.
Membrane treatment separates different kinds of contamination. Ultrafiltration addresses fine suspended material and larger molecules; reverse osmosis can reduce dissolved salts. Feedwater analysis and the required treated-water quality guide the process arrangement.
Share the fluid or gas, contaminant, flow rate, pressure and temperature. Our team can help you compare filtration, separation and purification options for the process.
Manufacturer availability varies by state and product line. Contact your local Fluid Flow team to confirm options for your facility.
Explore filtration and separation product families. Manufacturer representation and product availability vary by location; your local Fluid Flow team can confirm the options for your application.
TROUBLESHOOT THE CAUSE
Pressure drop reflects resistance through the housing, media and accumulated contamination. Compare readings under similar flow and fluid conditions. A faster rise can indicate a changed solids load, unsuitable media, inadequate area or an upstream process change; replacing the same element may leave the cause unresolved.
APPLICATION QUESTIONS
No. Finer particulate filtration does not address every dissolved contaminant or vapor. It can also increase pressure loss or changeout frequency. Identify the contaminant and required separation before changing the rating.
A gas coalescer removes entrained liquid droplets. A dryer removes moisture vapor to meet a specified dew point. A system may need both when liquid carryover and vapor are present.
Consider it when solids loading or repeated manual changeouts justify evaluating a regenerable design. Confirm retention requirements, cleaning effectiveness, utility availability and waste handling for the actual contaminant and operating conditions.
PREPARE FOR YOUR REVIEW
Bring the process medium, contaminant, target cleanliness and operating conditions. Add an element part number, housing photo or analysis report if available. Fluid Flow can help compare a replacement with a different treatment approach and review the product and regional support appropriate to your application.
CONNECTED APPLICATIONS
Compare liquid-filter media, contaminant loading and pressure loss.
Review feedwater quality, membrane protection and the required outlet specification.
Connect filtration with drying, demand and delivered air quality.
Review the heating, mixing or cleaning duty around the filtration stage.
APPLICATION SUPPORT
Tell us about your process, operating requirements and location. We’ll connect you with the team that supports your application.